https://help.junoviewerweb.com/pages/topic74-checking-data-in-the-forecast-view-in-junoviewer.aspx Acme Forum - Forecast View - Checking Data in the Forecast View in JunoViewer - Messages en-us http://blogs.law.harvard.edu/tech/rss Jitbit AspNetForum Thu, 10 Dec 2015 10:40:52 GMT Thu, 10 Dec 2015 10:40:52 GMT https://help.junoviewerweb.com/pages/topic74-checking-data-in-the-forecast-view-in-junoviewer.aspx
The outputs to pay particular attention to are deterioration rates, reset values, and treatment triggers, and a helpful way to check is having the Treatment Information, Audit Information, and Model Data tables open alongside the model. The recommended procedure would be:

Step 1: Select a treatment
Step 2: Open the Treatment Information table and ensure the information shown there is as expected (often these would be your starting values)
Step 3: Open the Model Data table and check the increments (deterioration rate) for the parameters are as expected; also check the reset values after a treatment are as expected.
Step 4: Open the Audit Information table and ensure all information is as expected. Specifically if you are running a lane specific treatment model take note of the difference between 'Model Triggered' and 'Model Triggered - Moderated'.

Refer to the figure below for instructions on the icons to click as well as information regarding each of the tables discussed above.



For help navigating the Forecast View toolbar, please refer to this post. For more information on the Forecast View, please click here.
edited by philip on 12/10/2015]]> Thu, 10 Dec 2015 10:40:52 GMT